Brookfield DV-I Prime Manual do Utilizador descarregar pdf (Página 26)

Brookeld Engineering Laboratories, Inc. Page 26 Manual No. M/07-022-D0613

When Temp Offset is enabled the temperature units display will be underlined.

Cp 0.0 70.1°F

0.0 RPM % 0.0

Figure II-33

NOTE: Temp. offset remains active when unit is powered down and powered up again.

II.10 Print Modes

NOTE: The print key is inactive when the motor is off. The printer must be attached to

the appropriate rear panel output connector. See Appendix G.

1. Press the print key once (less than 3 seconds) and DV-I PRIME will print one standard

line to a printer through the serial port output.

Figure II-34 shows examples of the print strings for CGS and SI units.

For the case of CGS units with non-exponential results:

and CGS units with exponential results.

Similarly, for SI units with non-exponential results.

and SI units with exponential results.

M = Torque T = Temperature Z = Time

11020304050607

RPM=XXX M=XXXXX S=XX %=XXX.X cP=XXXXX D/CM2=XXXXX 1/SEC=XXXXX T=XX.XC ZXX:XX

RPM=XXX M=XXXXX S=XX %=XXX.X cP=XXXeX D/CM2=XXXeX 1/SEC=XXXXX T=XX.XC ZXX:XX

11020304050607

RPM=XXX M=XXXXX S=XX %=XXX.X mPas=XXXXX N/M2=XXXXX 1/SEC=XXXXX T=XX.XC ZXX:XX

11020304050607

RPM=XXX M=XXXXX S=XX %=XXX.X mPas=XXXeX N/M2=XXXeX 1/SEC=XXXXX T=XX.XC ZXX:XX

Figure II-34

2. To initiate a continuous print mode, press and hold the print key for more than 3 seconds

and the following screen appears.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 70 71

Sem comentários

Brookfield DV-I Prime Manual do Utilizador Página 26