Brookfield KU-1 Viscometer Manual do Utilizador descarregar pdf (Página 8)

- 8 -

III. OPTIONS

III.1 Air Purge

The air purge option (Brookfield Part No. KU-1A) allows the interior of the KU-1or KU-1Q to be

pressurized with air (or an inert gas) when the instrument is to be used in a hazardous environment

(Figure 8). A built-in pressure switch turns the instrument off when the pressure drops below 2.0

PSI (falling). The switch comes on at 10.0 PSI (rising).

Connect a regulated clean air supply which is non-corrosive to brass to the fitting shown in

Figure 8. Adjust the pressure to approximately 25 PSI.

Note: The pressure switch range is 0-40 PSI.

DO NOT CONNECT PRESSURE HIGHER THAN 40 PSI TO THE SWITCH!

Power

Cord

Purge

Fitting

Power Cord

Purge Fitting

Figure 8: Back Panel Showing Air Connector

1 2 3 4 5 6 7 8 9 10 11

Sem comentários

Brookfield KU-1 Viscometer Manual do Utilizador Página 8