Brookfield DV-II+ Digital Viscometer Manual do Utilizador descarregar pdf (Página 44)

- 44 -

No Connection

Transmit Data (TxD)

No Connection

High Speed Print

(Note 1)

High Speed Print

(Note 1)

Serial Ground

Analog Ground

Analog % Torque

(Note 2)

Analog Temperature

(Note 3)

DV-II+

Serial and Analog Outputs

Notes:

1. Placing a jumper across pins 4 and 9 causes the DV-II+ to output

printer data at a 3 line-per-second rate. No jumper across pins 4

and 9 retains the once-per-second printer output rate.

2. This is a 0-1 volt d.c. output where 0 volts corresponds to 0%

torque and 1 volt corresponds to 100 % torque with a resolution

of 1 millivolt (0.1%).

3. This is a 0-4 volt d.c. output where 0 volts corresponds to -100°C

and 4 volts corresponds to +300°C with a resolution of 1 millivolt (0.1°C).

Figure G1

Analog Output:Analog Output:

Analog Output:

The analog outputs for temperature and % torque are accessed from the 9-pin connector located on

the rear panel of the DV-II+. The pin connections are shown in Figure G1.

The output cable (Part No. DVP-96Y) connections are:

Red Wire: Temperature Output

Black Wire: Temperature Ground

White Wire: % Torque Output

Green Wire: % Torque Ground

Note: Please contact Brookfield Engineering Laboratories or your local dealer/distributor for

purchase of the DVP-96Y analog output cable.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50 51

Sem comentários

Brookfield DV-II+ Digital Viscometer Manual do Utilizador Página 44