Brookfield R/S CPS Rheometer Manual do Utilizador descarregar pdf (Página 50)

BrookeldEngineeringLabs.,Inc. Page50 ManualNo.M08-218-B0212

Cause: An impermissibly high value was measured during the zero point cali-

bration of the rheometer.

Example

Message

Error #3

Zero cal. error!

Please retry cal.

<OK> cont. <ST> stop

What to Do:

a] press the

key

b] ensure the measuring system has been removed from the rheometer

c] retry zero point calibration - if error occurs again, this is an indication

of a fault in the measuring instrument

Cause: The maximum torque has been exceeded during a measurement. Pos-

sible reasons:

a] the measuring range is inappropriate for the measured sample

b] the cone or plate spindle cannot rotate on the measuring plate

Example

Message

ABORT:torque max!

Single measurement

total time: 60 s

total no. of MP: 10

What to Do:

a] press the

key

b] check whether the measuring system has been fastened properly at the

rheometer

c] if fastened properly, select smaller shear rates or speeds for this mea-

surement or use a measuring system with a higher shear stress factor

ABORT:TorqueMax

Zero Calibration Error

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 61 62

Sem comentários

Brookfield R/S CPS Rheometer Manual do Utilizador Página 50