Brookfield DV-I Prime Manual do Utilizador descarregar pdf (Página 16)

Brookeld Engineering Laboratories, Inc. Page 16 Manual No. M/07-022-D0613

S is blinking) the two character spindle value to the right of the S character will begin to change

(in either an increasing or decreasing direction depending upon which

ARROW key is pressed) for

each press of the key. If the

ARROW key is pressed and held, the display will scroll through the

spindle codes for as long as the

ARROW key is depressed. When it reaches the last item in the list

(either at the top or bottom of the list) the spindle code displayed will “roll-over” to either the

rst or last spindle code and the scroll action will continue.

When the desired spindle code is displayed, release the

ARROW key to halt further scrolling. Press

the

SELECT SPINDLE key once again. This will cause the S character to cease blinking and the new

spindle code will be accepted for use in viscometer calculations.

NOTE: You have approximately three seconds in which to press the SELECT SPINDLE

key before the blinking stops. If you fail to press the SELECT SPINDLE key

before the blinking stops you will have to repeat the above steps and re-select the

desired spindle.

The DV-I PRIME will begin to calculate using the new spindle parameters as soon as the SELECT

SPINDLE key is pressed the second time.

NOTE: The number 99 spindle is for use with special spindles when using Brookeld’s

WINGATHER32 computer program. Refer to WINGATHER32 operator manual

for further information on using “99” spindles.

DV-I PRIME remembers last spindle selected when power is shut down.

II.2.2 Spindle Section for Models WITH Temperature Display

The steps for selecting and accepting a spindle entry are the same as Section II.2.1 except that

when SELECT SPINDLE is depressed, the temperature display is temporarily replaced by the spindle

entry code until the entry code is accepted (Figure II-7):

cP 123.4 S31

10 RPM % 89.7

Figure II-7

Once the spindle entry code is accepted, the screen will return to the default display:

cP 123.4 70.1°F

10 RPM % 89.7

Figure II-8

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 70 71

Sem comentários

Brookfield DV-I Prime Manual do Utilizador Página 16