Brookfield DV-III Ultra Rheometer Manual do Utilizador descarregar pdf (Página 41)

Brookeld Engineering Laboratories, Inc. Page 41 Manual No. M98-211-E0912

Had the user selected a subset of a speed set (Figure IV-15), say speeds #04 through #08, then the

programmed mode (with a non-zero time interval) would result in the following display:

RPM:112 LK SPDL:31

TEMP:72.1°F PRTN

SET 2 04-08@04 PROG

TORQUE = 56.3 %

Figure IV-25

Here, the user is informed that speed set #2 is being used starting with speed number four and

ending at speed #08 while currently executing speed #04. After the rst speed (number #04) is

completed, the display would be updated to show the new speed and the step display would now

reect the current executing step number as in Figure IV-26 below.

RPM:120 SPINDLE:31

TEMP:72.1°C PRTO

SET 2 04-08 @05 PROG

TORQUE = 72.8 %

Figure IV-26

If the speed set contained no time interval, the selection of a subset of speeds would result in a

screen display as shown in Figure IV-27.

RPM:112 LK SPDL:31

TEMP:72.1°F PRTN

SUB 2 04-08@04 ENTER

TORQUE = 56.3 %

Figure IV-27

The step number would be incremented each time the user pressed the

ENTER key. Assume that the

speed corresponding to step #04 was executing. If the user presses the

ENTER key, our display will

be updated as shown in Figure IV-28.

RPM:120 LK SPDL:31

TEMP:72.1°F PRTN

SUB 2 04-08@05 ENTER

TORQUE = 72.8 %

Figure IV-28

S PROGRAMMED SPEED STOP

The user may stop program mode operation at any time by pressing the MOTOR ON/OFF/ESCAPE key

anytime during program operation. The following message would be displayed:

PROGRAM STOPPED

PRESS ANY KEY

Figure IV-29

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 132 133

Sem comentários

Brookfield DV-III Ultra Rheometer Manual do Utilizador Página 41