Brookfield DV-III Ultra Rheometer Manual do Utilizador Página 87

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 133
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 86
Brookeld Engineering Laboratories, Inc. Page 87 Manual No. M98-211-E0912
IV.8.6.3 Test Results
Test Passed
When a yield test runs successfully, the resultant Yield Stress (Pa), the % Torque value at the time
of the yield and the Temperature at yield are printed.
Test (#5: Sample Tst) Complete
Yield Stress (Pa) = 726.36 % Torque @ Yield = 73.56 Temperature = 25.5C
In addition, the results are shown on the display as follows:
#5: Sample Tst S:71
TEST COMPLETE
%=73.56 TEMP=025.5
YIELD=0726.4 Pa
Figure IV-84
Test Failed
Some of the reasons a yield test may fail are as follows.
Under-Range Condition
Only yield measurements in the % Torque range from 10% to 100% will be accepted. If a Yield
Stress is reached before the % Torque value is 10%, an Under-Range error causes the test to end.
The following is sent to an attached printer:
Test (#5: Sample Tst) Complete
Test Failed = Under-range
The following screen is displayed:
#5: Sample Tst S:71
YIELD ERROR
UNDER-RANGE
PRESS ESC OR ENTER
Figure IV-85
Under-Range Error
The yield stress (Torque Reduction Value) is reached before the absolute % torque reaches 10%.
When a test is started, once the absolute torque is greater than zero (0), the second, third, and fourth
Delta Torques (also known as the Base Increment Torque) are averaged. The rst three (3) Delta
Torques after 9% absolute torque is reached are also averaged. An under-range error occurs if the
second average falls below the rst average by 15% or more.
Over-Range Condition
Only yield measurements in the % Torque range from 10% to 100% will be accepted. If Yield
Stress is not reached before the measured % Torque value reaches 100%, an Over-Range error
causes the test to end.
The following is sent to an attached printer:
Test (#5: Sample Tst) Complete
Test Failed = Over-range
Vista de página 86
1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 132 133

Comentários a estes Manuais

Sem comentários