Brookfield YR-1 Rheometer Manual do Utilizador descarregar pdf (Página 28)

Brookeld Engineering Labs., Inc. Page 28 Manual No. M02-215-B0412

III. RUNNING TEST PROGRAMS IN STAND-ALONE MODE

This section explains how to use the YR-1 Rheometer in standalone mode. There are no test

programs stored in instrument memory when the YR-1 is shipped from Brookeld. Therefore,

you will need to review Section II on the EZ-Yield

Software which explains how to create

test programs. Once a test program has been downloaded from your PC to the YR-1, you will

be able to run tests by following the instructions in this section.

III.1 Autozero

Before any data may be taken, the rheometer must be Autozeroed. This action is performed

each time the instrument is powered on. The display on the rheometer will guide you through

the procedure as follows:

Set the power switch (located on the rear panel) to the ON position (press the l on the power

switch) and allow to warm up for 10 minutes.

After applying power to the unit, the display will read:

BROOKFIELD YR-1

YIELD RHEOMETER

Figure III-1

This text is displayed for three (3) seconds after which the display will read:

BROOKFIELD YR-1

RV VERSION 1.0

Figure III-2

Figure III-2 shows the instrument torque measurement range on the bottom left (in the case of

Figure III-2, RV) and the instrument rmware version number on the bottom right. This text

is displayed for three (3) seconds after which the display will read:

REMOVE SPINDLE

PRESS ANY KEY

Figure III-3

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 63 64

Sem comentários

Brookfield YR-1 Rheometer Manual do Utilizador Página 28