Brookfield YR-1 Rheometer Manual do Utilizador descarregar pdf (Página 30)

Brookeld Engineering Labs., Inc. Page 30 Manual No. M02-215-B0412

#5 Sample Tst ↑↓

START TEST

Figure III-7

Note: While the top line is the active selection line, the program number and name will

alwaysbeashing.

Pressing the · or ‚ key scrolls through the program numbers (0-9) and displays the corresponding

program name. While scrolling, if the slot scrolled to has no program in it, EMPTY is displayed

next to the program number, and pressing the Enter key has no effect.

Pressing the ESC key with this screen displayed causes the screen in Figure III-5 to again be

displayed (i.e. go back one level).

Once the sample is prepared and the Enter key is pressed with a valid program displayed, the

following screen is displayed:

USE SPINDLE #71

PRESS ENTER

Figure III-8

where the two (2) digit spindle number is displayed on the top line. Attach the appropriate

spindle and lower it into the sample before continuing.

Pressing the Enter key with Figure III-8 displayed performs the following:

• Thetestisstarted.

• Thepre-testinformation(testparameters)issenttoboththeserial(RS-232)portandtoan

attached printer via the parallel printer port. See section II.3 for a description of the pre-test

information sent to the printer.

• Theprogramnumberbeingrunisrecordedsothatitwillbetherstprogramshownthe

next time that START TEST is selected from the Default Screen (Figure III-5).

Pressing the ESC key at this screen causes Figure III-7 to be displayed.

After ensuring the appropriate spindle is attached and pressing the Enter key, the various Run

screens are displayed. The top line of the Run screens always displays the program and spindle

number as follows:

TEST #5 SPDL 71

---------------------------

Figure III-9

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 63 64

Sem comentários

Brookfield YR-1 Rheometer Manual do Utilizador Página 30